WebAddressed Matthias comments and added entry for DEV_SUPERSPEED. Added suspend_quirk in dwc3 host and moved the dwc3_set_phy_speed_flags. Added wakeup-source dt entry and reading in dwc-qcom.c glue driver. Changes in v2: Dropped the patch in clock to set GENPD_FLAG_ACTIVE_WAKEUP flag and setting in usb dwc3 driver. WebFeb 9, 2024 · USB Type C - Host OK use dwc3-0-host overlay. Enable P13 jumper to be able to use USB 2.0 device. USB Type C - Gadget OK use overlay to enable USB device mode. refer to this link: USB Type C - DisplayPort OK eMMC Boot OK SPI Boot Not Supported Recovery Button OK To use maskrom, jumper P13 must be enabled. ...
Re: [PATCH v3 2/3] usb: dwc3: gadget: Stall and restart EP0 if host …
WebMar 11, 2024 · The implementation of USB 3.0 on i.mx8m is based on DWC3 from Synopsys. There are two key points to implement OTG role switch: 1. OTG ID detection … WebThis comprehensive solution also includes support for Dual Role Device (DRD), xHCI Host, and Device Controllers and SuperSpeed InterChip (SSIC), High Speed InterChip (HSIC), … shubert furniture store
[PATCH v5 3/5] arm64: dts: rockchip: add rk356x dwc3 usb3 nodes
Web* * This function is used to release interconnect path handle. */ static void dwc3_qcom_interconnect_exit (struct dwc3_qcom * qcom) {icc_put (qcom-> icc_path_ddr); icc_put (qcom-> icc_path_apps);} /* Only usable in contexts where the role can not change. */ static bool dwc3_qcom_is_host (struct dwc3_qcom * qcom) {struct dwc3 * dwc = … WebNext in thread: Thinh Nguyen: "Re: [PATCH] usb: dwc3: gadget: Stall and restart EP0 if host is unresponsive" Messages sorted by: Hi Thinh, On 4/3/2024 6:11 PM, Thinh Nguyen wrote: On Fri, Mar 31, 2024, Wesley Cheng wrote: It was observed that there are hosts that may complete pending SETUP ... WebLinux debugging, tracing, profiling & perf. analysis. Check our new training course. with Creative Commons CC-BY-SA theo sommer ehefrauen